SIBOR Start Your Project
Toggle navigation menu

Custom Solar Engineering

Solar Panel Mechanical Integration: Choosing Frames, Adhesives, and Fasteners

October 26, 2026
A practical way to choose and validate the mounting method for a solar module built into an OEM product.
Read More →

Solar Battery Maintainers for Tractors and Agricultural Equipment

October 26, 2026
A selection and trial checklist for maintaining tractor and agricultural equipment batteries during seasonal storage.
Read More →

Common Custom Solar Panel Specification Mistakes

October 25, 2026
Custom solar panel specification mistakes often begin with a document that looks complete but leaves important assumptions unstated. A drawing…
Read More →

Designing a Solar Panel Into a Sensor Enclosure

October 24, 2026
What a sensor enclosure must preserve for a small solar module to work in the installed product.
Read More →

How Partial Shading Changes Small Solar Panel Performance

October 24, 2026
Partial shading of a small solar panel should be evaluated from the actual shadow pattern and electrical layout. Covering a…
Read More →

Solar Power Design for Cellular IoT Devices

October 23, 2026
A solar panel for a cellular IoT device should be selected from measured device behaviour, including communication activity. A brief…
Read More →

Choosing a Small Custom Solar Panel for Embedded Electronics

October 23, 2026
To choose a small custom solar panel for embedded electronics, start with the constraints of the finished device. The panel…
Read More →

How to Run a Solar Integration Design Review

October 21, 2026
A practical OEM checklist for reviewing the load, solar module, charger, storage, enclosure and validation plan before a custom solar…
Read More →

How to Choose a Solar Battery Maintainer for a Parked Vehicle

October 21, 2026
A solar battery maintainer for a parked vehicle should be selected around the battery and storage conditions, rather than a…
Read More →

Monocrystalline vs. Polycrystalline Solar Panels for Compact Products

October 20, 2026
For a compact OEM product, the monocrystalline-versus-polycrystalline decision is mainly a question of usable power within limited area, supply availability,…
Read More →